You are shopping for: Chrysler 5.7/6.1 Hilborn EFI Kit
Chrysler 5.7/6.1 Hilborn EFI Kit ID: EFI-6.1CH8/EL
Online Price: $5400.86

Retail Price: $5922.00

Description

This EFI kit includes an ECU that allows you to tune your engine simply and accurately without a laptop computer. The fuel injector manifold features a split throttle shaft design for smooth performance with gasoline set-ups.

Full Description

STANDARD EFI KIT INCLUDES THESE ITEMS: 
Fuel injector manifold assembled with TPS, fuel rails, & vacuum kit, injectors, wiring harness, Carabine ECU, two fuel filters, steel ram tubes, Weldon electric fuel pump and pressure regulator, and an MSD tach adapter. The entire package is factory tested on a wet flow bench to match the engine fuel flow requirements and comes with a step by step installation and tuning manual. 

OPTIONAL EFI KIT ITEMS: 
Remote thermostat housing 
0-60psi pressure gauge
Higher horsepower engines (600+ hp) may require higher flow injectors and/or fuel pump at a higher price

Engine Chrysler hemi 5.7L, 6.1L 

Bore Size 2-3/16" 
















PERFORMANCE PARTS / VEHICLE ALTERING NOTICE
Hilborn Fuel Injection systems are manufactured strictly for use with high performance engines for racing and off-highway use only, and are thus subject to the unusual stresses normally associated with this type of use.  Hilborn Fuel Injection parts may be used only on vehicles used solely in sanctioned off-highway events. No other applications are intended or implied. By adding this item to the shopping cart, you are acknowledging that this performance / vehicle altering product is for "OFF-ROAD USE ONLY".
DISCLAIMER & WARRANTY NOTICE
Hilborn Fuel Injection parts are sold "as is" due to the intended use in racing engines. Since the operation of these engines is far in excess of the safe limits that are usually set for engines, breakage and failures are common, and are an accepted risk in racing. Also, the history of racing has always been one of trial and error by the users of this type of equipment. Therefore, because of the many unknown factors involved in experimentation, and because of the safe limits being exceeded by virtually every part in the engine, we do not offer a warranty of any kind on our equipment. It is purchased and used by the buyer at his own risk and with this understanding. If any of our parts become defective after purchase, the buyer assumes all cost of service or repair.This means that Hilborn Fuel Injection parts sold by Mopar Supercenter carry no warranty whatsoever. Because racing is inherently dangerous, no representation of your safety is implied. To the extent permitted by law, this warranty is exclusive and in lieu of all other warranties or representations, whether expressed or implied, including any implied warranty of merchantability or fitness for a particular purpose. In no event will the manufacturer, distributor or retailer be liable for special or consequential damages. The entire risk as to quality and performance of these parts is with the buyer. Should such parts prove defective following their purchase, the buyer and not the manufacturer, distributor or retailer, assumes the entire cost of all necessary servicing or repair. 

MEMBERS REVIEWS

ADD REVIEW

Your Name
Your Email Your email will not be displayed on the site and is only for internal use.
Rate:
Review
SUBMIT REVIEW

Recently Viewed Items

Wheels - Wheel 18 Inch

Retail Price: $275.00

Online Price: $234.84

20" Wheel Redline Envy

Retail Price: $375.00

Online Price: $320.34

Six Pack Air Cleaner Assembly Kits

Retail Price: $376.00

Online Price: $320.34

Crown Front Brake Pads For 78 To 81 CJ's.

Retail Price: $45.00

Online Price: $25.08

Featured Products

News Letter Subscribe

2004 - 2018 Mopar supercenter. All rights reserved. All registered names and trademarks belonging to Manufacturers or Products are used as reference only